Metabo HPT C 12RSH2 Instrucciones De Seguridad Y Manual De Instrucciones página 17

CAUTION:
2. Checking the saw blade lower limit position
Check that the saw blade can be lowered 23/64" to 7/16" (9 mm to 11 mm) below the table
insert as shown in Fig. 11-a.
3. Lower limit position of saw blade when cutting a large workpiece
NOTE:
When cutting a workpiece exceeding 4-7/32" (107 mm) in height in right-
angle cutting or 2-3/4"(70 mm) in left bevel angle cutting or 1-3/4" (45 mm)
in right bevel angle cutting, adjust the lower limit position so that the
base of the motor head (see Fig. 11-a) will not come in contact with the
workpiece.
Lower limit position stopper of the saw blade
Hinge
Turntable
Fig. 11-b
To adjust the lower limit position of the saw blade, follow the procedure (1) shown in Fig. 11-a.
After adjusting the table insert for right angle cutting, the
table insert will be cut to some extent if it is used for bevel
angle cutting.
When bevel cutting operation is required, adjust the table
insert for bevel angle cutting.
6 mm depth
adjustment
bolt
Gear case
Saw blade
Fig. 11-a
6 mm depth
adjustment bolt
Turn
Gear case
Hinge
NOTE
: Confi rm that the saw blade is
adjusted so that it will not cut
into the turntable.
English
17