Metabo HPT C 12RSH2 Instrucciones De Seguridad Y Manual De Instrucciones página 26

English
CAUTION:
* When cutting a workpiece of 4-3/4" (120 mm) height, adjust the lower
* If the handle is pressed down with excessive or lateral force, the saw
* In slide cutting, gently push the handle back (rearwards) in a single,
WARNING:
* For slide cutting, follow the procedures indicated above in Fig. 28.
* Always return the carriage to the full rear position after each
* Never put your hand on the side handle during the cutting operation
7. Bevel cutting procedures
Clamp
Lever
Indicator
(for right
bevel scale)
Bevel
scale
Fig. 29
WARNING:
26
limit position of the motor head so that the gap between the lower
edge of the motor head and the workpiece will be 5/64" to 1/8" (2 to
3 mm) at the lower limit position.
blade may vibrate during the cutting operation and cause unwanted
cutting marks on the workpiece, thus reducing the quality of the cut.
Accordingly, press the handle down gently and carefully.
smooth operation.
Stopping the handle movement during the cut will cause unwanted
cutting marks on the workpiece.
Forward slide cutting (toward the operator) is very dangerous
because the saw blade could kick upward from the workpiece.
Therefore, always slide the handle away from the operator.
crosscut operation in order to reduce the risk of injury.
because the saw blade comes close to the side handle when the
motor head is lowered.
Holder (A)
Set pin (A)
Pull
When the workpiece is secured on the left or right side of the
blade, the short cut-off portion will come to rest on the right or
left side of the saw blade. Always turn the power off and let the
saw blade stop completely before raising the handle from the
workpiece.
(1) Loosen the clamp lever and bevel the saw blade to
the left or to the right.
When tilting the motor head to the right pull the set
pin (A) towards the rear.
The clamp lever adopts a latchet system. When
contacting the work bench and the main body,
pull the clamp lever in the direction of the arrow
mark as illustrated in Fig. 29, and change the
direction of the clamp lever.
(2) Adjust the bevel angle to the desired setting while
watching the bevel angle scale and indicator, then
secure the clamp lever.
(3) Follow the procedures indicated in paragraphs
4,5 and 6 above. For maximum dimensions for
bevel cutting, refer to "SPECIFICATIONS" table on
page 10.