Ninja BN300 Serie Manual Del Propietário página 5

USING THE NINJA® NUTRI-BLENDER
1 Plug in power pod and place on a clean,
dry, level surface such as a countertop
or table.
2 Add ingredients to the Ninja Cup. DO
NOT add ingredients past the MAX
LIQUID line on the cup.
3 Place the Blade Assembly on the top of
the cup and turn clockwise to seal.
4 Turn cup upside down so the bottom of
the blade assembly is flat on the worktop.
8
ninjakitchen.com
5 Place the cup on the power pod. Press
down on the cup to pulse or blend.
6 When blending is complete, lift up the
cup to remove.
7 Turn cup over so blade assembly is on top.
Twist blade assembly counterclockwise to
remove. To take your blended contents on
the go, place the spout lid on cup and turn
clockwise to seal. Do not store with the
blades attached.
CARE & MAINTENANCE
CLEANING
1 Separate all parts.
2 Wash all containers in warm, soapy water
with a soft cloth.
Hand-Washing
Wash cups, lids, and blade assembly in
warm, soapy water. Use a dishwashing
utensil with a handle to avoid direct
contact with the blades. Exercise care
when handling the blade assembly as the
blades are sharp. Thoroughly rinse and
air-dry all parts.
Dishwasher
Cups, lids, and blade assembly are
dishwasher safe. Ensure the blade
assembly and lid are removed from the
cup before placing in the dishwasher.
Power Pod
Unplug the power pod before cleaning.
Wipe power pod with a clean, damp cloth.
NEVER directly spray the pod with
water or other liquids.
DO NOT use abrasive cloths/pads/brushes
to clean the pod, as this can dull or scratch
the surface.
RESETTING THE MOTOR THERMOSTAT
This unit features a unique safety system
that prevents damage to the motor and
drive system should you inadvertently
overload it. If the unit is overloaded, the
motor will be temporarily disabled. Should
this occur, follow the reset procedure below.
1
Unplug the power pod.
2
Allow the power pod to cool for
approximately 15 minutes.
3 Remove the blade assembly. Empty the
container and ensure no ingredients are
jamming the blade assembly.
IMPORTANT: Ensure that maximum
capacities are not exceeded. This is the
most typical cause of appliance overload.
ninjakitchen.com 9