Publicidad
Idiomas disponibles
Idiomas disponibles
Because of the distance to the (combustible)
wall, the protection plate may not be removed in the
back shield.
1. Apply supplied fibre glass sealing tape (2) meas-
uring 10 x 3 mm to the connection collar's contact
surface (1).
2. Fit the connection collar to the top plate with the
materials supplied (3).
Preparing the outside air
connection
If the appliance is installed in a room with insufficient
ventilation, you can install the outside air connecting
kit to the appliance.
The air supply tube is 100 mm in diameter. If the tube
is smooth, it may be no longer than 12 metres. If
accessories such as bends are used, the maximum
length (12 m) must be reduced by 1 m for each acces-
sory used.
Outside air connection via the wall
1. Make an opening in the wall (see the appendix,
"Measurements", for the correct position of the
opening).
2. Close the air connection hermetically to the wall.
11
Installing and connecting
1. Position the appliance in the correct place, and
make sure it is level. The appliance is fitted with
adjustable feet so that it can be levelled.
2. Connect the appliance to the flue hermetically.
3. For outside air supply connection: connect the out-
side air supply to the connection kit which is fitted
to the appliance.
4. Re-position all removed parts to the correct places
in the appliance.
Never use the appliance without the fire-resist-
ant inner plates.
The appliance is now ready for use.
Use
First use
When you use the appliance for the first time, make
an intense fire and keep it going for a good few hours.
This will cure the heat-resistant paint finish. This may
result in some smoke and odours. You could open win-
dows and doors for a while in the area in which the
appliance is located.
Subject to change because of technical improvements.
Publicidad
