Descargar Imprimir esta página

Camp4 916883 Manual Del Usuario página 15

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 26
CAMP4 l Trolley Gas Grill | 916883/916884
8.2. Conduct in the event of malfunctions and leaks/in the case of fire:
(e.g. smell of gas, noise of escaping gas):
Close the cylinder valve im-
Do not smoke!
mediately (clockwise)! Ex-
Do not actuate any electri-
tinguish any naked flames!
cal switches!
Contact a specialist!
Do not use the telephone!
8.3. Operation of liquid gas cylinder systems
• Liquid gas cylinder systems should only be installed, commissioned, modified and checked by specialised companies.
• Liquid gas cylinder systems should only be installed in the commercial sector by trained personnel and checked by an appro-
priately qualified person or, when dealing with certain cylinder systems, by a person assigned by the contractor.
• The cylinder must be set in an upright position. Cylinders positioned on their side pose a threat of deflagration.
• The operating instructions provided by the manufacturer of the liquid gas appliance are to be observed carefully by the user
for operation and, if necessary, for troubleshooting measures. Prior to the initial operation, or after making a modification, the
operator of a liquid gas cylinder system must be assured of its orderly condition through examination and certification by a
specialised company (commercial systems are to be addressed by a special person responsible for the respective commercial
sector). The certificates from the examinations are to be kept by the operator.
• If the system is not going to be used for a prolonged period the valves are to be closed; when doing this start from the device
shut-off valve towards the cylinder valve. When starting up the system again the valves are to be opened; when doing this start
from the cylinder valve towards the device shut-off valve.
• Naked flames and smoking are prohibited in areas where large cylinders are stored and in close proximity to large cylinder
systems. The ventilation openings of the installation area and/or the cylinder cabinet must be kept free. Warning signs must
be applied.
• The operator is prohibited from siphoning liquid gas!
8.4. Changing the cylinder
• When changing the cylinder only loosen the regulator connection after the cylinder valve has been fully closed. The pressure
regulator must be connected and well sealed. Every time the cylinder is changed the seal of the regulator connection must be
tested using foaming agents (e.g. soapy water).
• For multi-cylinder systems: Close the shut-off valve of the container connecting line; set switch to full cylinders.
Regulator connection small cylinder
(5 and 11 kg nominal capacity)
Cylinder valve closed
8.5. Transport and storage
• To avoid damaging the valve and to prevent gas leaks full and empty liquid gas cylinders should only be transported and
stored with a closed and protected valve (wear nut and cap).
• When transporting in vehicles it must be ensured that there is adequate ventilation in the storage area. The cylinders must be
secured from shifting during transport.
• The cylinders, even if they are empty, should only be stored upright in well-ventilated areas; they should not be stored below
ground level (e.g. basements, shafts, etc.), in stairwells, corridors, passageways, near emergency exits, escape routes and
passages between buildings or in their immediate vicinity. No more than two small cylinders should be stored in a home - and
only then in separate rooms (not bedrooms).
(in buildings/vehicles)
additionally:
Open windows and doors!
Transfer any leaking cylinders
outside immediately!
Evacuate the building/vehicle!
Soft sealing ring in the cylinder valve
Screw the regulator by hand
(left-hand thread)
Notify the fire department !
Point out the presence of liquid
gas cylinders!
If possible, remove cylinders from
any area that is susceptible to fire
or cool with water if necessary
Regulator connection big cylinder
(33 kg nominal capacity)
Cylinder valve closed
Sealing ring (alumini-
um or plastic) on the
regulator side
15
Tighten the regulator with a
spanner (left-hand thread)
DE
EN
IT
ES
FR
NL
FI
DK
SE

Publicidad

loading

Productos relacionados para Camp4 916883

Este manual también es adecuado para:

916884