Mettler Toledo VFS120 Manual De Instrucciones página 21

4.8 Print
The print function can be initiated by pressing
settings.
Automatic print occurs after the gross weight exceeds the minimum threshold
and there is no motion on the scale. And then, the gross weight must return to
less than the reset threshold before new print can occur.
Automatic print may be disabled or enabled. Please refer to F4.2.1 in Chapter
of Terminal Configuration.
Automatic print can be triggered and reset by weight thresholds or weight
deviation.
For more information about the print setting, refer to the chapter of "Terminal
Communication"
4.9 Applications
4.9.1 Check-weigh
The Check-weigh can compare the current weight with the target weight,
and decide the comparison result.
Whenever another function is active, such as counting, X10, or animal
weighing, check-weigh cannot be started and a warning message"—
no--"will appear for a short time Figure 5-1.
The
weigh status.
4.9.1.1 Check-weigh Configuration
Figure 5-1 Warning message
symbol in the top line indicates the check-
1. Set the check-weigh target. Take the example as below:
Target weight = 5.000kg
Tolerance + = 1.000kg
Tolerance - = 1.000kg
2. Press or (whichever is assigned to Check-
weigh) to enter the target editing screen.
appear at the top of the screen. If there is stable weight on
the platform, it will be detected as an original target value.
"------"indicates that the terminal is attempting to detect a
stable weight. The target can be selected in one of two ways:
or by automatic print
will
21