Mettler Toledo VFS120 Manual De Instrucciones página 22

22
a. If a stable weight is detected before the approximately
0.5 second timeout elapses, "target" will appear for one
second, then the detected stable weight will display.
b. Otherwise, the terminal will show "Target" for 1 second,
and then display zero weight (Figure 5-2). Press
accept this current value as the target and move to the next
screen, "Tolerance -".
3.
set "Tolerance-" value by using the direction keys. In this
example (Figure 5-2, center), the low tolerance is set to 1
kg. Press
4.
"Tolerance+" value by using the direction keys. Here (Figure
2 12, right), the high tolerance is set to 1 kg.
Figure 5-2: Target and Tolerance Displays: Target (left), Low (center) High (right)
4.9.1.2 Check-weigh Operation
1. Press
enter the check-weighing. The weight status is indicated as
follows (based on the configuration set in the Configuration
section, above).
• Under
• OK
• Over
Figure 5-3: Under, OK and Over
2. Once check-weigh is completed, press
application and return to basic weighing.
appears at upper left in the display. Now, you can
to move to the next screen, "Tolerance +".
appears on the top of the screen. Now, you can set
or (whichever is assigned to Check-weigh) to
Below 4kg; (Figure 5-3, left )
Between 4kg and 6kg; (Figure 5-3, center)
Above 6kg; (Figure 5-3, right)
to
to exit the