TOPDON PHOENIX ADAS MOBILE PX1000 Manual Del Usuario página 24

1.3.11 Laser range finder
The laser range finder is used to measure the height from the target / pattern board to the ground.
Since the laser range finder is not on the same level as the target board/pattern board, a precise tolerance
value is preset in the ADAS calibration software for all vehicles and no more settings and calculations are
required by users. When measuring the height, just follow the onscreen prompt height value to perform the
calibration.
It is a Class 2 laser product in accordance with IEC 60825-1:2014. The product and batteries must
not be disposed of with household waste.
1. Laser
Warning: Do not stare into the laser beam or direct it towards other people.
2. Battery power indicator
3. Display screen
4. Measured result
5. Measurement unit
To switch between the measurement units, triple click the
6. POWER button
Long press - turn the meter on / off.
Short press - Start / pause measuring.
7 . Battery compartment
Technical parameters:
Range
Accuracy
22
POWER button.
0.1 ~ 25m (0.33~82ft)
± 1/152ft
www.topdon.com