Publicidad
Idiomas disponibles
Idiomas disponibles
2 Initial Use
2.1 Place the calibration frame
By default, it is folded for easier shipment. Follow the steps below to unfold it.
The heavy tool may tilt down and cause injuries, remember to always unfold the tool with the aid
of a second person.
1. Take out the calibration frame and place it on a flat ground.
2. Push the lever (14) upwards as indicated in the following figure, and then pull the rolling caster (13) down
on the ground.
3. Repeat step 2 for other two rolling casters.
4. Hold the handle (19) and raise the lifter up slightly off the ground, these rolling casters will be fully
unfolded and firmly sit on the ground automatically. Then lay the lifter down.
24
www.topdon.com
Publicidad
