Publicidad
Idiomas disponibles
Idiomas disponibles
6. Hold the handle in one hand and align
with openings in top of motor housing.
Push down firmly onto top of handle
until snaps into position.
7. Your vacuum comes ready for dry
vacuum cleaning. If the reusable cloth
filter is not installed, refer to page 18 for
installation instructions.
8. For wet vacuum cleaning, remove the
reusable cloth filter, and install the
supplied foam wet filter. See page
19 for the foam wet filter installation
instructions.
9. Place the powerhead back on the
collection tank aligning the top section
with the latches, and snap into place.
10. Insert the large end of the hose onto
the vacuum port on the collection tank.
ASSEMBLY INSTRUCTIONS
- 11 -
11. Choose the desired accessory and insert
onto the end of the hose or extension
wand.
For your convenience this vacuum comes
with a wall mounting support for storage.
IMPORTANT!
• Do not mount the rack over 5 feet from
the floor.
• Do not screw the wall mount rack to
drywall only. Secure the screws to a
stud.
• Do not hang from or sit on the vacuum
when on wall mount rack.
• Do not use the vacuum while it is
mounted on the wall mount rack.
• Empty the collection tank before
mounting the vacuum on the wall.
12. Make sure the rack is level and mark
the hole locations. Align the two screw
holes so that they are over a stud and
secure the mount rack to the wall stud
with the two screws provided.
Publicidad
