Publicidad
Idiomas disponibles
Idiomas disponibles
If the function is activated
automatically, the Fan
indicator will not light up.
The activation of the Fan
function may increase the
noise and energy
consumption.
The fan operates only when the door is
closed.
4.10 High temperature alarm
When the temperature in the freezer
compartment increases (for example due
to an earlier power failure), the alarm
indicator flashes, the freezer temperature
indicator shows H° and blinks and the
sound is on.
To deactivate the alarm, press any
button.
The alarm indicator and sound go off.
The freezer temperature indicator shows
H° for 5 seconds before indicating the
freezer temperature again.
The alarm restarts one hour
after deactivation until the
normal conditions are
restored.
If you do not press any
button, the sound switches
off automatically after
around one hour to avoid
disturbing.
4.11 Door open alarm
If the fridge door is left open for
approximately 5 minutes or if the freezer
door is left open for approximately 80
seconds, the sound is on and the door
open alarm indicator turns on. The
internal fridge light may also start
flashing.
The alarm stops after closing the door.
Press any button to switch off the sound
and flashing of the internal fridge light.
If you do not press any
button, the sound switches
off automatically after
around one hour to avoid
disturbing.
4.12 Air filter change indicator
When the air filter has expired and
requires replacement, the Air filter
change indicator and the Filter Reset
alarm indicator turn on.
Refer to "Installing and replacing the
CleanAir+ filter" section in "Care and
cleaning" chapter for the replacement
instructions.
After the filter replacement, press the
Filter Reset alarm button to turn off the
alarm.
4.13 Setting mode
The Setting mode allows you to:
• Enable or disable the ECOMETER
indicator
• Enable or disable the button sounds
• Change the temperature units from °C
to °F
• Reset the appliance to factory settings
Activating the Setting mode
To activate the Setting mode:
1. Press and hold the ECO button for
approximately 3 seconds. When the
Setting mode is being activated, the
display shows a blinking
2. Once the Setting mode is switched
on, the display shows
To deactivate the Setting mode, press
and hold the ECO button for
approximately 3 seconds.
The Setting mode deactivates
automatically if you do not interact with
the control panel for 60 seconds.
Navigating the Setting mode
1. Activate the Setting mode (refer to
"Activating the Setting mode").
The display shows
2. Tap the fridge temperature button (on
the left) to change the parameter.
Tap the freezer temperature button
(on the right) to change the
parameter value.
ENGLISH
11
.
.
.
Publicidad
