Sony VPL-FH500L Manual De Referencia Rápida página 48

C VPLL-ZM101
shading sheet
Before attaching the projection lens to the
projector, it is required to attach the shading
sheet supplied with the lens adapter after
attaching the lens adapter.
1
Remove the two screws from the lens
adapter.
2
Fit the shading sheet to the projection
lens as illustrated and fasten it to the
lens with the two screws.
22
GB
Attaching/Removing the Projection Lens
*1
: Attaching the
Shading
sheet
Removing
1
Loosen the four screws that secure the
front panel (1), and remove the front
panel, pulling it forward (2).
2
Loosen the four screws that secure the
projection lens then pull it out straight.
When loosening the screws, support the
lens with your hands so that it will not
fall.
Screws
Note
If the lens was shifted with lens shift
adjustment, the screws may be too
constricted to loosened. In such a case,
adjust to shift the lens to the center position
(page 11).
*1: VPL-FX500L only.
Screws