MADER MF360L+TI360 Manual De Instrucciones página 46

Adjusting bolt
Guard ring
4. Handle of Output Clutch
● The handle of output clutch mainly controls the work of attachment.
● The attachment starts to work when the handle is in the position of ON while it stops working when the
handle is in the position of OFF. See the diagram 25.
● The output clutch cannot be debugged unless it is connected to attachment. Please see the direction
bellow on B5.
Handle of output shaft
5. Handle of Worm Wheel Clutch
● The handle of worm wheel clutch mainly controls the running of rubber tires. See the diagram 26.
● When the handle is in the position of ON, the rubber tires can run; While the handle is in the position of OFF,
the tires cannot run, but can be propelled. See the diagram 26.
● The Debugging of Worm Wheel Clutch: Debug it without starting up. When the handle is in the position of
ON, rubber tires cannot be propelled. If not, please turn the adjusting bolt towards inner side. When the
handle is in the position of OFF, rubber tires can be propelled. If not, please turn the adjusting bolt towards
the outward side. See the diagram 26.
Adjusting bolt
Handle for emergency
shutdown
Diagram 23
OFF
ON
Adjusting bolt
Diagram 25
Diagram 26
Input clutch handle
Output shaft
OFF
Handle of worm wheel
Diagram 24