Publicidad
Idiomas disponibles
Idiomas disponibles
3 Infuse lubricating oil SAE 80W-90 into oil filler point of gear case, when it comes to the position of L, check
with oil dipstick whether oil lever locates between the upper limit and lower limit. Fill in the oil dipstick after that.
(See the diagram 40)
Floor limit
● To change lubricating oil of clutch
Attention
As the engine oil used is baneful, it cannot be disposed like general waste. Send to the
recommended local special recycle bin.
1 Place engine at horizontal position and unscrew oil plug. (See the diagram 38)
2 Put an appropriate container for old oil under the engine. Then remove the oil dipstick, oil drain bolt and
gasket. After all the engine oil is drained, replace and screw down the oil drain bolt and gasket. (See the
diagram 39.)
3 unscrew the screw of oil level hole. (See the diagram 41)
4 Infuse lubricating oil SAE 80W-90 into oil filler point of clutch case till the floor limit of oil level hole. Finally,
screw up bolt and oil plug.
● To clean up air filter
Dirty filter core will reduce the machine life. If air filter is not used or outworn filter core is not
changed, dust and some other dirty materials will enter the gasoline engine, resulting in
acceleration of energy abrasion.
1 Remove wing nut, and remove elements that should be cleaned up. (See the diagram 42)
Wing nut
Bowl-shaped gasket
Upper limit
Diagram 40
Diagram 41
Outer casing
Filter core backup washer
Diagram 42
Screw of oil level hole
Filter core
Filter core supporting plate
Publicidad
