Publicidad
Idiomas disponibles
Idiomas disponibles
2. Turn the handle of output clutch to the position ON. See the diagram 25.
3. For the easy installation of the accessories, please elevate the rear part of gasoline engine for about 20cm
to keep the machine almost in the horizontal position. See the diagram 30.
4. Pull up the hand shank of the dowel pin and stick the connecting parts of the accessories into the hole of the
accessories' connector bush. When the connecting parts stick into the bottom, pull down the hank shank of the
dowel again. Revolve the accessory slightly and make sure that the dowel pin can stick into the dowel hole of
the accessories' connecting parts. See the diagram 31
Hand shank of the
dowel pin
Accessories'
connector bush
5. Debug of the output clutch: When the hand shank is in position "ON", pull the petrol engine slightly then the
working parts of the accessories can revolve. If the working parts of the accessories cannot revolve, please
debug the bolt inside. When the hand shank is in position "OFF", the working parts of the accessories cannot
revolve. If they can revolve, please debug the bolt outside. See the diagram 25
C Start-up Operation
1. Infuse the petrol engine with lubrication oil
● Choose proper brand of the lubrication oil according to the temperature differences in working condition. Use
SAE 10W-30 and SAE 30 generally. See right-hand chart
● The normal lubrication oil quantity for the petrol engine is ranging from 0.6L to 0.9L.
● .When the petrol engine is in horizontal position, refuel the oil to the lower edge of the oil hole. See the
diagram 32
● Attention: Any use of dirty or other brands of the lubrication oil will impact the petrol engine's working life!
Below the normal state when refuelling will also damage the petrol engine badly!
Diagram 30
Diagram 31
Diagram 32
Publicidad
