Publicidad
Idiomas disponibles
Idiomas disponibles
2. Infuse the fuel oil into the fuel tank of the petrol engine
● Choose the specified brand of the fuel oil reasonably.
● Infuse the oil to the position with plate "Fuel level" when refuelling the fuelling. See the diagram 33
●Attention: Do not use the adulterants added or water added, unqualified, and improper brand of the fuel oil,
they will cause start-up difficulty of the petrol engine!
Too much fuel oil will also cause petrol engine's start-up difficulty!
3. Open the fuel tap in the direction of the identifying arrow. See the diagram 34
4. When the cold engine starts up, place the hand shank of the choke to "closed" position in the direction of the
identifying arrow. When the thermal engine starts up, place the hand shank of the choke to "open" position.
See the diagram 34
Switch identifier of
the fuel tap
5. Place the flameout switch of the petrol engine in position "ON". See the diagram 35
6. Press down the emergency stop handle and grab the handle of the input clutch. See the diagram 23.
7. Pull the handle of the output clutch in position "NO". See the diagram 25
8. Pull the handle of the turbine clutch to position "OFF". See the diagram 26.
9. Move the speed controller from "low velocity" to "high velocity" where is about 1/3 from the highest speed.
See the diagram 28
10. Pull up the starting handle slightly until feeling resistance, then drag it out abruptly. See the diagram 36
Attention: Do not rebound the starting handle abruptly, but put it back slightly!
Diagram 36
Diagram 33
Identifier
choke's hand shank
Diagram 34
Starting handle
Fuel level
Choke's hand
of
the
shank
Fuel tap
Diagram 35
Off
On
Publicidad
