Publicidad
Idiomas disponibles
Idiomas disponibles
2) 3 Screw in the spark plug with hand, and then tighten it with spark plug cap.
Attention 1. Overheating or damage may occur on gasoline if not screw down the spark plug; however, over
screwing-down may hurt screw thread.
2. Correct ways for screwing up:
With new spark plug, please screw 1/2 circle more after compressing spark plug gasket.
With old spark plug, please screw 1/8-1/4 circle more after compressing spark plug gasket.
3. Recommended spark plug: F7RTC or others with same rank.
Operation
1. It is forbidden to place your feet or hands near the rotating parts (see warning messages).
2. Be especially careful when working on pavements, sidewalks or motorways. Be aware of potential hazards
and pay attention to traffic.
3. Stop the machine when it hits hard objects and check the machine for damage. If it has been damaged, repair
it before using it again.
4. Always pay attention to the passage. Avoid slipping or falling.
5. When the machine is experiencing abnormal vibrations and noise, stop the engine and try to find out why.
Vibration usually precedes a malfunction.
6. Before repairing the blade lock, in case of maintenance, adjustment or inspection, the engine must be
switched off.
7. When the machine is not operated by a worker, all safety measures must be taken: separate power cable,
lower clamp, set for idling, lock the engine and turn off the fuel switch.
8. Before cleaning, repairing or inspecting the machine, stop the engine and make sure that all moving parts are
stopped.
9. Do not work indoors, as the waste gases emitted by the engine are harmful to health.
10. The protective device must be installed. Do not use the machine without the appropriate protective
equipment, guards or protective devices (see warning messages).
11. Keep away from children and animals.
12. Do not overload the machine with working depth and high speed.
13. The machine must not be operated at high speed on slippery roads. Observe the rear when operating in
reverse and operate the machine with care.
14. It is forbidden to have people near the machine when it is in operation (see warning messages).
15. The muffler temperature is very high when the machine is running. Touching the machine while it is in
operation can cause personal injury (see warning messages).
16. Use only devices and equipment permitted by our company.
17. Do not operate the machine in low light.
18. Be careful when operating the machine on solid ground, as the blade may get stuck by pushing the low
forward. If this happens, release the machine without trying to control it.
19. Avoid tripping when operating the machine when going up or down a mountain.
Diagram 45
0.7mm-0.8mm
Publicidad
