EUFY RoboVac L35 Hybrid Manual Del Propietário página 13

Use Mopping System
•
The mopping mode is only intended for a clean floor without stubborn stains
or liquids. To avoid staining floors, do not use the mopping function when
dust is mixed with liquids such as coffee or ink.
•
Mopping System cleans best on smooth hard surfaces and may not perform
so well on uneven tiles, heavily waxed floors or rough surfaces like slate or
brick, which may snag the mopping module.
•
The mopping mode is not recommended when no one is at home.
•
Do not use the mopping mode on a carpeted floor. It is recommended to set
a "No-Mop" zone in the EufyHome app to avoid cleaning the carpeted area.
1
Before mopping, install the waterproof pad under the Charging Base to protect
the floor.
2
Remove the mopping module.
22 EN
3
Wet the mopping cloth and wring it until it does not drip, then attach the cloth to
the mopping module.
4 Remove the water tank. Open the water inlet cover to fill the water, then close the
cover.
Do not use any cleaning solution, as your floor may become slippery and
therefore affect the cleaning effect.
5
Install the mopping module and water tank back into the bottom of RoboVac until
a click is heard.
The mopping mode is only intended for a clean floor without stubborn
stains. To achieve a better mopping effect, it is recommended to clean the
floor with RoboVac three times before mopping.
EN 23