Publicidad
Idiomas disponibles
Idiomas disponibles
Real-Time Mapping and Floor Plan
Real-time mapping helps RoboVac easily learn the environment of your home to generate
the most efficient cleaning path. A floor plan will be built after cleaning. The map will be
updated in real-time during each cleaning session to ensure normal navigation.
To create a complete floor plan:
1. Open your doors so that RoboVac can map each room.
2. Remove any objects that may be in the way or that might entangle RoboVac.
Repositioning and Remapping
If the position of RoboVac / Charging Base is adjusted or the surroundings are changed
significantly, RoboVac will try to reposition and remap to match the surroundings.
•
If the repositioning is successful, RoboVac will resume cleaning.
•
If the repositioning fails, RoboVac will remap to ensure normal navigation with a new
cleaning.
•
When using for the first time, make sure RoboVac starts cleaning from the
Charging Base.
•
During cleaning, do not move RoboVac frequently. If moved, place RoboVac
back to the original position.
Using Your RoboVac
Important Tips Before Use
A
B
D
E
14 EN
C
F
Remove power cords and small objects from the floor that may entangle RoboVac.
Fold tasseled edges of rugs underneath to prevent tangling RoboVac. Avoid
cleaning dark-colored high-pile rugs or rugs thicker than 1.02 in / 26 mm as they
may cause RoboVac to malfunction.
It is strongly recommended to set a No-Go zone or a virtual boundary in the
EufyHome app in front of fireplaces and certain areas (i.e. air vents) that may
cause damage to RoboVac if entered.
Keep RoboVac away from wet areas during cleaning.
RoboVac may climb on top of objects less than 0.79 in / 20 mm in height.
Remove these objects if possible.
Anti-drop sensors will prevent RoboVac from tumbling down stairs and steep
drops in most cases. Sensors are less effective if dirty or used on carpeted /
reflective / dark-colored floors. It is recommended to place physical barriers or set
a No-Go zone / a virtual boundary in the EufyHome app to block off areas where
RoboVac may fall.
Preparation
1
Remove the foam blocks beside the bumper before use.
2
Before mopping, attach the Charging Base to the waterproof pad to keep the floor
dry. Make sure it is firmly installed. Skip this step if mopping is not needed.
EN 15
Publicidad
