GreenWorks PSF301 Manual Del Operador página 8

6. Put the chain in position and make sure that the
loop is behind the guide bar.
7. Hold the chain and bar.
8. Put the chain loop around the sprocket.
9. Make sure the chain tension pin hole on the guide
bar fits correctly with the bolt.
10. Install the chain cover.
11. Tighten the chain. Refer to Adjust the chain tension.
12. Tighten the chain cover knob when the chain is well
tensioned.
NOTE
If you start the machine with a new chain, have a test
for 2-3 minutes. After that, examine the tension again
and tighten the chain if necessary.
3.4 FIT THE POLE SAW
Figure 2-3
1. Mount the pole saw head on pole saw handle to
achieve the standard length.
2. Slide the collar upwards.
3. Turn the collar clockwise to tight it.
3.5 EXTENSION OF THE POLE SAW
Figure 2-3
1. Fit the extension pole between the pole saw handle
and the pole saw head to achieve the maximum
length.
2. Slide the collars upwards.
3. Turn the collars clockwise to tight them.
WARNING
Periodically check the tightness of the connection
of the collars.
3.6 USE THE SHOULDER STRAP
Figure 7
1. Attach the carabiner to the carrying ring on the pole.
2. Put on the shoulder strap.
3. Adjust the length of the strap so that the carabiner is
about the width of a hand below your right hip.
3.7 CUTTING PREPARATION
Figure 7
Before you start to cut, make sure that
• Wear heavy gloves for maximum grip and
protection.
English
• Maintain a proper grip on the machine during
operation.
• Use your right hand grip on the rear handle while
your left hand grip on the pole shaft.
• Keep your body to the left of the chain line.
• Never use a left-handed (cross-handed) grip, or
any stance that places your body or arm across
the chain line.
• Never stand directly under the limb you are cutting.
• Periodically examine the tightness of the collars
during operation.
3.8 INSTALL THE BATTERY PACK
Figure 5
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.9 REMOVE THE BATTERY PACK
Figure 5
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4 OPERATION
Remove the battery pack and keep hands clear of the
lock out button when you move the machine.
Examine the chain tension before each use.
4.1 EXAMINE THE CHAIN OIL
Do not use the machine without sufficient chain oil.
Figure 4
1. Examine the oil level of the machine from the oil
indicator.
2. Add more oil if it is necessary.
5
WARNING
NOTE
IMPORTANT
NOTE
EN