Fanimation TRIAIRE SHOWROOM MAD8514 M Serie Manual Del Usuario página 7

How to Assemble Your Ceiling Fan
1. Remove the three stabilizer tabs and plastic bag
from the motor. Discard the stabilizer tabs. (Figure 1)
2.
Prior to assembly, set aside and save the hardware
bags packaged with your fan. Remove the hanger ball
by loosening the set screw in the hanger ball until the
ball falls freely down the downrod. Remove the pin
from the downrod, then remove the hanger ball.
Retain the pin and hanger ball for reinstallation in
Step 7. (Figure 2)
3. Remove the hairpin clip and clevis pin from the
bottom of the downrod. Retain the pin and clip for
reinstallation in Step 5. (Figure 3)
4.
Loosen the two set screws and locking nuts in the
downrod support of the motor assembly. Route the
brown, blue, red, gray and yellow wires through the
downrod. (Figure 4)
5. Slide downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes in
the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Install the two set
screws with nuts in the downrod support. Securely
tighten the set screws with screwdriver then fully
tighten the nuts using a hex wrench. (Figure 5)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in
the fan falling.
Motor
Assembly
Downrod
Hanger
Ball
Hairpin Clip
Set Screws
and Nuts (2)
Set Screws
and Nuts (2)
7
Stabilizer
Tabs
Figure 1
Figure 2
Clevis Pin
Figure 3
Brown, Blue, Red, Gray
and Yellow wires
Figure 4
Downrod
Figure 5
Pin
Set screw
Clevis Pin
Hairpin Clip