Start & Stop Procedure - Altrad Belle RTX 50 Manual Del Operador

GB
GB
CAUTION
WARNING
Honda GX100 & GX120
handle until engine resistance is felt, then allow the starter to return.
of this machine has been preset at the factory to achieve optimum machine performance.
RED Engine Stop button.
original position. This will prevent any air or humidity from entering into the cylinder.
Yanmar L48
handle until engine resistance is felt, then allow the starter to return.
the engine starts.
4. Taking care not to pull the starter rope fully out, pull the starter handle briskly.
CAUTION
7. After the engine has warmed up, the machine is ready for operation.
of this machine has been preset at the factory to achieve optimum machine performance.
Start & Stop Procedure
Improper operation can be hazardous. Read and understand this section before you start the machine.
immediately stop the machine from vibrating.
STARTING position (Halfway between HIGH and LOW
CLOSED position.
RUN position.
the oil port and reinsert the oil plug.
OPEN position.
LOW position.
LOW position.
14
STOP position