Troubleshooting Guide; Service & Maintenance - Altrad Belle RTX 50 Manual Del Operador

GB
Problem
Engine will not start
Engine stops suddenly, or stops when
the engine rpm is increased.
Engine runs, but machine does not
produce impact.
GB
Maintenance
The Altrad Belle RTX Range is designed to give many years of trouble free operation. It is, however, important that the simple regular
maintenance listed in this section is carried out.
It is recommended that an approved Altrad Belle dealer carries out all major maintenance and repairs. Always use genuine Altrad Belle
replacement parts, the use of spurious parts may void your warranty.
Before any maintenance is carried out on the machine, switch off the engine. If working on a petrol engined machine, disconnect the
HT lead from the sparkplug.
Always set the RTX
Servicing the Engine
Yanmar L48 Engine Priming
below instructions.
CAUTION
the tank.
Injector Pipe Nut (Item 2).
NOTE:- DO NOT
Diesel is running freely without any air bubbles.
section of this manual.
Trouble Shooting Guide
Cause
No fuel
Engine not primed. (GX100 Only)
Engine not primed. (Diesel Only)
Spark Plug contaminated or damaged.
(Petrol Only)
(Petrol Only)
See Above
Main jet of the Carburettor clogged with
dirt. (GX120 Only)
Spark plug cap is loose. (Petrol Only)
Lack of engine power
Clutch is slipping
Crank mechanism is damaged
Service & Maintenance
RUN position.
(Item 1) by loosening the
(Item 3)
Remedy
Open fuel tap.
Push the Carburettor Primer Bulb 4 times and
See the Service & Maintenance section of this
Manual.
Replace spark plug.
Service the Carburettor
See Above
Take out the main jet of the Carburettor and
clean with Compressed air.
Clean the element.
See above.
Dismantle clutch assembly, Clean shoe and
drum with proper solvent. Replace clutch
shoe if necessary.
Contact Dealer.
16
1
2
3