1
Introduction
These instructions describe the assembly and operation of the ORTHO guide set MT3.
1.1
Symbols used
Symbols with the following meanings are used in these instructions or on the equipment:
Danger
Immediate danger of injury. Consult accompanying documents!
Electrical voltage
Danger due to electrical voltage.
Caution
Risk of damage to the equipment if the instruction is not followed.
Notice
Provides the operator with useful information that eases use.
2
Safety
2.1
Intended use
The ORTHO guide set MT3 can be used to extend the MT3 trimmer with an orthodontic trimmer table.
2.2
Ambient conditions for safe operation
The ambient conditions for the trimmer shall apply.
2.3
Hazard and warning information
2.3.1
General information
► If the unit is not used in accordance with the supplied operating instructions, the intended safety
can no longer be guaranteed.
► Disconnect the unit from the mains power supply before carrying out work on the electrical parts.
► Defective equipment must be taken out of service immediately. Disconnect the power plug and
secure the equipment against further use. Send the equipment in for repair!
► Information on REACH and SVHC is available on our website at www.renfert.com, in the Support
area.
2.4
Authorized persons
Operation and maintenance of the equipment may only be performed by trained personnel.
Any repairs not described in these operating instructions may only be performed by a qualified electrician.
2.5
Disclaimer
Renfert GmbH shall be absolved from all claims for damages or warranty if:
► The product is employed for any purposes other than those specified in the operating instruc-
tions.
► The product is altered in any way other than those alterations described in the operating instruc-
tions.
► The product is not repaired by an authorized dealer or if original Renfert spare parts are not used.
► The product continues to be used despite obvious safety defects or damage.
► The product is subjected to mechanical impact or is dropped.
- 1 -
en