Renfert ORTHO guide Set MT3 Manual De Instrucciones página 6

3 Product description
en
3.1 General description
You can extend the MT3 model trimmer using the ORTHO guide set MT3.
The orthodontic model table and template enable precise trimming of the planning and diagnostic models.
3.2 Assemblies and functional elements
See Fig. 1 (on inside cover)
1 Orthodontic model table
2 Template
3.3 Scope of delivery
1 Orthodontic model table
1 Template
1 STEP-BY-STEP instructions
1 Assembly instructions
Demonstration models, 1 x upper jaw, 1 x lower jaw
4 Startup
4.1 Assembly – orthodontic model table
⇒ Pull the attached model table upwards from the ball head at the front edge and remove it.
⇒ Turn the adjustment fork to the 90° position with the long side facing upwards (see also the operating
instructions of the trimmer).
⇒ Insert the orthodontic model table and press it onto the ball head again.
⇒ Attach the template.
5 Operation
The handling of the orthodontic model table and the template can be found in the enclosed step-by-step
instructions.
There you will also find a link to user videos.
6 Cleaning / maintenance
6.1 Orthodontic model table and template
The orthodontic model table can be cleaned in the same way as the standard trimmer model table.
⇒ Remove the template.
⇒ Pull the model table upwards from the ball head at the front edge.
⇒ Clean the model table and the template using a brush as appropriate under running water.
Do not use any objects with sharp edges or solvent-based / abrasive cleaning agents.
- 2 -
Subject to change