SOMFY Tilt Only 50 WF RTS Central Manual página 19

Tilt Only 50 WF RTS Central
2.3.2. Checking the direction of rotation
Press the Up button on the RTS control point:
a) If the slats tilt in the desired direction, the
direction of rotation is correct: go to section
2.3.3. Setting the end limits.
b) Otherwise: move onto the next step.
• b1) Press the my button of the RTS control
point until the motorised product moves up
and down. The direction of rotation has been
modified.
b2) Press the Up button on the RTS control
•
point to check the direction of rotation.
2.3.3. Setting the end limits
The end limits can be set in any order.
Attention
Do not set an end limit in a position capable of li ing the motorised
product as this could damage the motorised product and/or the
motor in the long term.
1) Place the motorised product in the desired
lower position by pressing the Down button.
2) Press the my and Up buttons simultaneously
until the motorised product moves. The lower
end limit is now memorised and the green LED
flashes five times.
3) Press the my button when the motorised
product reaches the desired upper position. If
necessary, adjust the position of the motorised
product using the Up and Down.
4) Press the my and Down buttons simultaneously
until the motorised product moves. The upper
end limit is now memorised and the green
LED flashes five times.The motorised product
moves down and will stop at its lower end limit.
5) To confirm the end limit settings, press the my button until the motorised
product moves up and down. The end limits have been programmed.
Copyright 2019 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
©
a
=
b
=
b1 b2
1 2
3 4
5
EN
19