SOMFY Tilt Only 50 WF RTS Central Manual página 20

EN
2.3.4. Programming the RTS control point
The drive is in programming mode:
Briefly press the PROG button on the RTS control
point to be programmed:
The motorised product moves up and down:
this RTS control point is programmed in the drive and the green LED flashes five
times.
If the drive is no longer in programming mode, repeat step 2.3.1. Pre-
programming the RTS control point before performing step 2.3.4.
Programming the RTS control point.
2.4. TIPS AND RECOMMENDATIONS FOR INSTALLATION
2.4.1. Questions about the drive ?
Observations
The motorised
product does
not work.
20
Possible causes
There may be some radio
interference.
One or more batteries are
installed the wrong way.
One or more batteries are
leaking in the battery housing
tube.
The batteries (in the battery
tube) are low.
The control point battery is
low.
The control point is not
compatible.
The control point used has
not been programmed into
the drive.
Copyright 2019 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
©
Tilt Only 50 WF RTS Central
PROG.
Solutions
Disconnect the power supply
cable, then reconnect the
battery to the drive.
Check that the batteries are all
installed correctly.
Replace all the batteries.
Check the battery power
levels and replace if
necessary.
Check the battery power level
and replace if necessary.
Check for compatibility and
replace the control point if
necessary.
Use a programmed control
point or program this control
point.