Publicidad
Idiomas disponibles
Idiomas disponibles
5. Put the ends of the cutting lines through the holes.
6. Extend the cutting line to release it from the guide slot in
the spool.
Line exit hole
7. Push the tabs and install the spool cover onto the spool
housing.
8. Push the spool cover until it clicks into position.
11.4
REPLACE THE CUTTING LINE
NOTE
Remove the remaining cutting line on the spool.
Use only with the nylon cutting line of 0.065" (1.65 mm)
diameter.
1. Cut two pieces of cutting line approximately 3m long of
each.
NOTE
English
2. Bend one end of the line 1/4 of an inch (6.35mm) .
3. Put the lines into the anchor holes of the spool.
4. Wind the cutting lines around the spool tightly in the
indicated direction.
5. Put the cutting lines in the guide slots.
6. Do not wind the cutting line beyond the edge of the spool.
12
TRANSPORTATION AND
STORAGE
Remove the battery pack from the machine before
tranportation and storage.
12.1
STORE THE MACHINE
•
Remove the battery pack from the machine.
•
Make sure that children cannot come near the machine.
•
Keep the machine away from corrosive agents such as
garden chemicals and de-icing salts.
•
Secure the machine during transportion to prevent
damage or injury. Clean and examine the machine for any
damage.
11
WARNING
EN
Publicidad
