Westinghouse ePX3100 Manual De Usuario página 17

CARE AND MAINTENANCE
Maintenance parts can be purchased directly from the factory. A partial list of maintenance parts is below. For a
complete list of maintenance parts or for additional information email us at
1-855-944-3571
call
Inlet Filter ..............................................................................................................................................02000432-0
Turbo Nozzle ...........................................................................................................................................03000272
Soap Nozzle .........................................................................................................................................04000388-0
0˚ Nozzle ..............................................................................................................................................03000271-0
15˚ Nozzle ............................................................................................................................................03000266-0
25˚ Nozzle ............................................................................................................................................03000270-0
WARNING
product. Making unauthorized modifications and using incompatible accessories can damage the unit and
void your warranty.
TROUBLESHOOTING
PROBLEM
Unit will not turn on.
The unit is running but
there is no water flow.
Water is leaking where
the hose connects to
the spray gun.
The pressure washer
turns on for 2 seconds,
shuts off, and will not
turn back on.
.
Do not use attachments or accessories that are not recommended for use with this
POSSIBLE CAUSE
Pressure washer is not connected to a power
source or the power source isn't grounded
Water pressure is in the hose
GFCI is tripped
Defective motor or power cord.
Improper water source
Clogged nozzle
Defective spray lance
Defective or missing O-ring between the high
pressure hose and the spray gun.
The auto-start feature is turning the unit off.
service@wpowereq.com
CORRECTION
Connect the power cord to a grounded
120 Volt outlet
Pull the trigger to release the water
pressure.
Press the RESET button on the power cord
Contact Westinghouse customer service
toll-free at 1 (855) 944-3571.
Connect the pressure washer to a water
main. Do not use this device with water from
a lake, pool, pond, etc.
Clean the nozzle
Replace the lance
Replace the o-ring.
When the pressure washer is turned on, the
motor may run for 1 - 2 seconds to prime
the pump. Then it will automatically shut
off until the spray gun trigger is squeezed.
This is normal and does not indicate a
problem.
or
English | 17