STERWINS 20VGSS2-2IN1.1 Instrucciones De Montaje página 223

FR
8.3 TROUBLESHOOTING
ES
PT
Problems
IT
EL
Product does
not start
PL
Product does
not reach
full power
RU
Vibration
or noise is
excessive
KZ
Product
UA
suddenly stops
RO
*Over current means "Self-protection"."Self-protection" mode is a degraded mode, limited in
time (we recommend a maximum duration of 5 minutes) during which the use of the product is
EN
made impossible so that the product can recover its initial state.
8.4 FATAL CIRCUMSTANCES
machine smokes during operation
9. END OF LIFE
Electrical products should not be discarded with household products. Used electrical
products must be collected separately and disposed of at collection points provided
for this purpose. Talk with your local authorities or dealer for advice on recycling.
DANGER ! RISK OF INJURY DUE TO ELECTRIC SHOCK.
WARNING ! BEFORE ANY TROUBLE SHOOTING, SWITCH OFF THE
PRODUCT.
Probable causes
Battery is not charged
Wrong startup steps
Battery capacity too low
Bolts/nuts are loose
Battery discharged
Battery too hot
Product maybe
over current*
Problems
Solutions
Charge the battery
according to the
instructions included
with your model
Refer to chapter
"Switching on/off"
Charge battery
Tighten bolts/nuts
Charge battery pack
Let it cool down
Stop the product and wait
for 3 minutes to restart
Solutions
Immediately stop the machine, Remove the
battery pack then speack to service center
222
Qualification
required
-
-
-
-