Kärcher HDS 2000 Super Manual De Instrucciones página 21

4.7 Connecting the water
• • • • •
See technical data, chap. 3 for connected
loads.
• • • • •
Attach the supply hose to the appliance and to
the water line. The supply hose is not included
in standard delivery.
• • • • •
If you draw in the water from an open tank,
you should
– disconnect the water supply from the pump
head
– unscrew the upper supply hose from the
water tank and connect to the pump head.
– use a water supply hose which has a
minimum diameter of 3/4" and a suction
filter.
• • • • •
Until the pump has drawn in the water, you
should:
– rotate the pressure and volume control to
"MAX",
– close the detergent metering valve.
4.8 Connecting the power
• • • • •
See technical data, chap. 3 for connected
loads.
• • • • •
The voltage stated on the rating plate must
correspond to the voltage of the power source.
• • • • •
First, position the appliance switch to "STOP"
and then put the electric plug into the socket.
• • • • •
If the motor rotates in the wrong direction, the
electronic control circuit will switch the motor
off after a few seconds. The INCORRECT
MOTOR ROTATION warning light illuminates.
Disconnect the power input plug. This plug is
equipped with a device for reversing polarity.
Apply a screwdriver at the prescribed point,
press it inwards and rotate both terminals
through 180°.
Attach the power input plug again.
• • • • •
If you are using an extension lead, it should
always be completely unwound from the cable
drum and have an adequate cross-section.
Mains voltage 10 m
230 V 6 mm²
400 V 4 mm²
All manuals and user guides at all-guides.com
4. Start-up
30 m
10 mm²
6 mm²
4.9 Intended use
• • • • •
Use the appliance to clean machines,
vehicles, buildings, tools, etc.
• • • • •
Clean facades, patios, garden implements,
etc. with the high-pressure spray only, i.e.
without detergent. We recommend the dirt
blaster, a special accessory, for stubborn
dirt.
• • • • •
If the machine is used at petrol stations or in
other hazardous areas, the appropriate safety
regulations must be observed.
• • • • •
Please ensure waste water containing mineral
oil
does not contaminate soil, lakes and rivers or
the sewerage system. Therefore, please wash
engines and underbodies only in appropriate
washing installations provided with oil traps.
HDS 2000 Super
GB
21