Publicidad
Step 11
Fasten two EXTENSION RAILS (40MA) to the ENDS (A and B). Use
å
four GOLD 5/16" FLAT HEAD SCREWS (3S) through holes #1 and #4.
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole
å
shown in the enlarged diagram. Then, slide the inner cartridge of the
EXTENSION RAIL in to fi nd the other hole that lines up with the hole in
the END. Turn a SCREW into this hole.
GOLD 5/16" FLAT HEAD SCREW
(4 used for the RAILS)
Open end
www.sauder.com/service
3S
4
3
B
2
1
3
4
A
These holes
must be here.
426484
7
Open end
1
2
Page 17
Publicidad
