Publicidad
Step 24
1
D133
K
Groove
Insert the DRAWER SIDES (D133 and D139) at an angle
å
into the slot at each end of the DRAWER FRONT (K).
3
BLACK 9/16" LARGE HEAD SCREW
(2 used for the BRACKET)
77G
Fasten the DRAWER BACK (D77) to the DRAWER SIDES (D133 and D139). Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
å
NOTE: Be sure the DRAWER BOTTOM (D708) inserts into the groove of the DRAWER BACK (D77).
å
Repeat this step for the other drawer.
å
Fasten the Z-LOCK BRACKET (77G) to one of the DRAWER FRONTS (K) exactly as shown. Use two BLACK 9/16" LARGE
å
HEAD SCREWS (1S).
Page 30
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D139
1S
D133
D708
2
D133
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D708) into the
å
grooves in the DRAWER SIDES (D133 and D139)
and DRAWER FRONT (K).
D77
D139
K
426484
With the palm of
your hand, tap
the DRAWER
U n fi
BOTTOM down
n i s h
s u r
into the groove.
e d
f a c
e
D708
D139
K
Start each screw a few turns before
completely tightening any of them.
30S
BLACK 1-9/16" FLAT HEAD SCREW
(8 used in this step)
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
www.sauder.com/service
9
Publicidad
