Publicidad
Step 26
1
D430
J
Groove
Insert the FILE DRAWER SIDES (D429 and D430)
å
at an angle into the slot at each end of the FILE
DRAWER FRONT (J).
3
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
Fasten the FILE DRAWER BACK (D78) to the FILE DRAWER SIDES (D429 and D430). Use four BLACK 1-9/16"
å
FLAT HEAD SCREWS (30S).
NOTE: Be sure the FILE DRAWER BOTTOM (D708) inserts into the groove of the FILE DRAWER BACK (D78).
å
Repeat this step for the LOCKING DRAWER FRONT (W).
å
Page 32
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D429
D78
D430
D708
2
D430
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the FILE DRAWER BOTTOM (D708) into the
å
grooves in the FILE DRAWER SIDES (D429 and D430)
and FILE DRAWER FRONT (J).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D429
426484
With the palm of
your hand, tap
the DRAWER
U n fi
n i s h
BOTTOM down
s u r
e d
f a c
into the groove.
e
D708
D429
J
30S
(8 used in this step)
www.sauder.com/service
9
Publicidad
