Publicidad
Idiomas disponibles
Idiomas disponibles
GENERAL SPECIFICATIONS
SAFETY REGULATIONS
The manufacturer declines all liability for failure to comply with the safety regulations and recommen-
dations described below. The manufacturer also declines all liability for damage caused by improper
use of the convector fan and/or by modifications made without authorization.
The convector fan must be installed by expert, authorized personnel.
· Wear adequate safety clothing when installing the machine, e.g. goggles, gloves, etc.
· Work in a safe, clean and uncluttered place when installing the appliance.
· Comply with the laws in force in the country where the convector fan is installed during use and when dispo-
sing of the packaging materials and products used to clean and service the appliance. Also comply with the
instructions given by the manufacturers of such products.
· Comply with the pertinent anti-pollution laws if the convector fan is dismantled.
· It is absolutely forbidden to touch moving parts or to get between the same.
· Before starting the convector fan, make sure that its parts and the whole system are in a perfect condition.
· Spare parts must comply with the requirements established by the manufacturer. Only use genuine spare
parts.
· It is absolutely forbidden to touch moving parts or to move between the same.
· Only qualified personnel may be allowed to service or replace damaged or worn parts of the convector fan.
Moreover, such work must be carried out in compliance with the instructions in this manual.
· before proceeding with the servicing or cleaning operations, make sure that the unit is not connected to the
electricity main and that it cannot be accidentally powered.
This installation manual must be read, memorized and kept ready to hand throughout the life of the
convector fan .
PRELIMINARY OPERATIONS PRIOR TO INSTALLATION
Comply with the following instructions before beginning to install the appliance:
· Make sure that all parts of the convector fan are in a perfect condition.
· Make sure that the appliance has not sustained damage during transport. Immediately notify the haulage
contractor if damage is discovered. Check to make sure that the accessories required for installation and the
relative documentation are included in the pack. As a further safeguard, the grille is supplied in a separate
pack. Remote control kits (if applicable) are also wrapped separately.
· Convey the packed appliance as near to the installation site as possible.
· Do not stack weights or place tools on top of the packed appliance.
32
Publicidad
