Publicidad
Idiomas disponibles
Idiomas disponibles
TOOLS REQUIRED FOR INSTALLATION
The following tools are required in order to install the
convector fan:
· Pipe wrench for the wet connections
· Flat tip and cross-headed screwdrivers
· Drill
· Scissors
ACCESSORY PARTS NORMALLY AVAILABLE ON THE MARKET AND REQUIRED FOR INSTALLATION
The following items are also required for installation purposes:
· Water pipe unions
· Condensation-proof tape
· Adhesive tape
BEFORE INSTALLATION
Transporting the unit packed as close as possible to the place of installation.
IMPORTANT: Do not move the unit through the exhaust pipe of the condensate or attacks; grasp on
the four corners.
The installation of the unit will be facilitated using un'elevatore The fan must be installed in a position to allow
routine maintenance and repairs, as well as access to the air vent valve on the side of the unit (housed in the
water connections). (See figure 1-2 position indication hatch )
In the case of plasterboard false ceilings the housing unit must be no larger than 660x660 mm (for models 200-
300-400) and 900x900 (for models 500-600-700).
In the case of environments with high humidity, isolate the hanging brackets with the appropriate insulating
adhesive supplied.
Mod .04-08-10
max 660
max 660
34
INSTALLATION
· Wire stripper
· Pipe cutters
· Pipe benders
· Measuring tape
· Level
· Goggles and protective gloves
Fig. 1
Mod .12-16-21
max 900
max 900
Fig. 2
Publicidad
