Graf one2clean Manual Del Usuario página 23

5. Installing the control one2clean unit indoors
1.
The control unit should be installed in a dry, dust-
free indoor location. To install, drill two 8mm holes
in the wall.
3.
The compressor is placed on top of the control
unit. Use the rubber bracket for the air connection.
The compressor's connector is plugged into the
socket on the control unit.
5.
The aeration hoses are connected to the two 3/4"
hose connectors. The sludge return hose is con-
nected to the 1/2" connection.
5. Installing the control one2clean unit indoors
The control unit is secured to the wall with the
dowels and screws supplied.
The hose for clear water extraction (1/2") is di-
rectly connected to the black hose connector on
the control unit. The additional air distributor is
connected to the control unit's blue hose con-
nector (3/4").
For information about starting up the wastewater
treatment system and setting the control unit, refer
to the operating logbook.
23 / 52
2.
4.