Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
Scratch or remove the sealing tape and take out the unit.
1.
Follow the ATTACHMENT to check all items and to see if there are any omissions.
2.
Check the unit is correct and whether it matches with order model.
3.
Check whether the unit has defects or is damaged due to defectiveness or transportation.
4.
Make sure all packaging is disposed of responsibly and in accordance with the current regulations in your region.
5.
1 x EV Charger & 1 x Fixing bracket *
Wiring cap
CT**
* NOTE: It is integrated from factory, and separated when installed.
** Just for charger with power management
*** Both for charger with power management and OCPP
TOOLS/MATERIALS REQUIRED (NOT INCLUDED)
Electric drill
Phillips screwdriver
ATTACHMENT
1 x Installation template
1 x Sealing rubber
CT wire terminal**
Measuring tape
Slotted screwdriver
UNPACKING
Installation location
There should be a certain space around the machine for
installation and f uture maintenance
Wall or other fixed objects that cannot be moved
SUGGESTION: a (side gap): minimum250mm
WARNING:
1. T his unit m ust be grounded.
2. T his unit s houl d be i nst alled by a lic ens ed el ectrici an i n ac c or danc e wit h
loc al buil di ng and el ectric al c odes and st andar ds, clim at e c onditions, s af ety
st andar ds , and all applic- abl e c odes and or di nanc es.
140.2mm
4-Installation hole：φ6*35
24.5m m
The cable entr y h ole
24.5mm
4 x Wall Plugs
1 x Cable Gland
1 x Sealing rubber***
Safety gloves
Pencil
7
electric vehicle charger
1 x Manual
1 x Elbow wrench
4 x Screw
M6x30
ST4.2x32
1 x Charger holder
Electric elbow tool
Hole Saws
Mode 1: Φ24mm Bottom hole
(for the single phase)
Mode 2: Φ18mm (Back hole for
Sealing rubber)
V.1
Publicidad
