Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
MODE 1
a1. Check the cable gland parts as shown in fig. 5.
a2. Pass the gasket and the main body through the opening hole of the shell and lock it with a nut, as shown in
Fig. 6.
a3. Insert the pressing head into the cable, and then thread the cable into the main body that cannot be
pulled off, as shown in Fig. 7.
a4. Trim and cut the cable to the proper length, lock the pressing head to secure the cable.
a5. Refer to this article connect electrical wiring to connect the cable to the terminal block.
NOTE: connecting wiring reference fig. 4
WARNING: To ensure the rated IP protection level of the product, must use the cable gland in the accessories.
a6. Confirm and remove the debris inside the housing caused by punching and wiring.
a7. Ensure that all cables are connected correctly and securely, and are not loose or damaged.
a8. Screws lock the front and rear shells tightly.
Caution: Need to use the screws removed from the original position.
Before installing the front shell, it must be ensured that the sealing strip in the front shell groove has not
fallen off and is in the right position. Ensure that all seals performed on the unit can reach the IP rating.
a9. Screw the unit to the fixed bracket.
Caution: Use the screws removed from the original position.
Note: a8, a9 refer to fig. 1, reverse operation.
Built-in
Gasket
sealing ring
Pressing head
Main body
MODE 2
b1. Insert the sealing rubber into the housing, as shown in Fig 8, insert the bare wire into the sealing rubber, one
hole corresponds to one bare wire, after all the wires are inserted, leave enough length of the cable to connect
to the terminal block.
NOTE1: To ensure the rated IP protection level of the product, must use the sealing rubber in the accessories.
NOTE2: Poke the middle position of the sealing rubber before installing this item.
b2. Screw fastening the entire rear shell to the fixing bracket.
Caution: Use the screws removed from the original position.
b3. Refer to this article connect electrical wiring to connect the cables to the terminal block.
NOTE: connecting wiring refer to fig. 4
b4. Seal the opening on the back to achieve the unit's IP rating.
Warning: sealing is very important. This involves the safety of the product and must be paid attention.
b5. Screws lock the front and rear shells tightly.
Caution: Use the screws removed from the original position.
Before installing the front shell, it must be ensured that the sealing strip in the front shell groove has not fallen off
and is in the right position.
Make sure that all seals performed on the unit can reach the IP rating.
Note: if there is no suitable electric tool, the elbow wrench provided in the accessories can be used to tighten the
screws of the front and rear shells.
IMPORTANT NOTE: It is the responsibility of the installing engineer to satisfy themselves, that all cable termi-
nations throughout this product are secure and tight and have not become loose, strained, or disconnected
during transit and/or installation.
Nut
lock it with the nut
The built-in sealing ring
must not fall off
Pass the gasket and the main
body through the opening
hole of the shell
fig. 5
fig. 6
13
fig. 7
V.1
Publicidad
