Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
1. Installer or end user must read and understand all the content covered in this manual before installing or
using this unit.
2. Choose a suitable installation location according to the installation conditions stated in the warning.
3. Make sure that the installation location complies with current laws and regulations.
4. Confirm that there is a suitable input voltage power supply at the installation site (consistent with the
nominal power supply of the product).
5. Make sure the supplied fixings are suitable for the mounting location. If not suitable, alternatives must be
obtained locally before proceeding with the installation.
There should be a certain space around the unit for
installation and future maintenance.
SUGGESTION:
a (side gap): minimum 250mm.
*A charging cable holder position needs to be reserved.
(Just for connector charger and cable)
▲ Make sure that the power source is turned off before installing the unit.
▲ Manufacturers and distributors are not responsible for any loss or related responsibilities caused by any
incorrect installation.
▲ The installer shall be responsible for the loss and damage of the product, system or property caused by
improper installation.
Important:
Before installing the unit, it necessary to confirm the way of the product's power cable entry. Mode 3 power cable
entry is strictly prohibited.
Mode 1
Bottom entry
(Best choice)
√
Cable
Cable Gland
BEFORE INSTALLATION
INSTALLATION LOCATION
WARNING
Mode 2
Back entry
√
Sealing rubber
Cable
8
Wall or other fixed objects that cannot be moved
Mode 3
It is strictly forbidden to pass the
bottom line through the back.
×
Cable
V.1
Publicidad
