Publicidad
Idiomas disponibles
Idiomas disponibles
2.The charger needs to be connected to WiFi. If the WiFi signal is weak or absent, the charger will not receive
the signal or delay the connection. Therefore it is recommended to add an enhancement device for WiFi
receiving signal near the charger. Note: To check if your WiFi can reach the charger and have a good signal
check your smart device or smart phone whilst standing close to the charger with the WiFi tuned on if the signal
can be seen above 2 bars then it is ok if not a WiFi booster or repeater needs to be added. Note: The ethernet
port is not for the smart App it is only for OCPP use.
Step 6-1: Click Add.
Step 6. After clicking ADD, enter the wifi and wifi password, wait for the device to connect to the network.
Step 7. If you need define a new device name, click "
is successful.
Step 8: Click the corresponding
device.
Step 8. Click the relevant device icon to enter the device control interface.
Step 9. The first connection will appear the default selection interface, you can select the default mode,
edit the charging time or select the manual mode.
Step 10. Click manual mode.
Step 11. After connecting to the car, then charging without any operation.
APP INSTRUCTION
Step 6-2: Enter wifi name and
password, then click the next
Step 10-1: Default selection interface
Step 6-3: Loading
" if not need, click "done" to confirm the connection
Step10-2:Device control interface
17
Step 7
V.1
Publicidad
