Publicidad
Idiomas disponibles
Idiomas disponibles
Setting
15
((1). Order input: Input order tab.
you can set power management from this tab. To use this function a CT clamp is required. To set maximum
current:
1. Click Input order tab to enter command input field.
2. Input "home value", this value is the limited protection value of household entry current, the setting range is
08-120, and the factory default setting is 45A (the system will automatically optimize the current value when
the actual value is 5A less than the value set); the setting value is recommended to be set according to the
rated current value of the total household current.
(2). Set Current tab(A): You can set max charging current, max charging current not more than the current of DIP
switch setting.
NOTE：1. After the APP is connected at the first time, the current value displayed here is not the set current
value, it is a current setting form.
2. It will take effect only after clicking to enter to set any current value, and the current value adjustment range
is 6-32A;
3. If the current value has never been set here, the value displayed here is invalid
(3). Temperature Monitor: can check device interior temperature value.
Setting
(4).IP Address: Change the address of the OCPP back-office server；
(5).ID：The product name in the OCPP back-office server.
NOTE:1.make sure the ID is only.
2. After the ID is replaced, it can be concluded that the ID replacement is complete only when the Device
number is consistent with the replaced ID;
If the Device number does not change after changing the ID, you can exit the APP and then power off and
restart the EV charger.
3. After the IP or ID is replaced, it must be powered off and restarted to take effect.
APP INSTRUCTION
Input order
Function
HOME value
Set household entry current
RESET
Clear all charging data
NOTE:
If the order is inputed incorrectly, the
device will still beep twice, but the order will
not be executed;
The wrong order that was inputed cannot be
corrected, until you disconnect device from
the APP and wipe the data and connect it
again.
21
V.1
Publicidad
