Johnson DYNAMO74 Manual De Instrucciones página 45

SOLAR ENERGY APP INTERFACE DESCRIPTION
After clicking ECO on the APP, a "√" appears next to it, indicating that the mode is set successfully, and then
set "ON" or "OFF" to determine whether to plug the gun and charge.
ON: plug the gun and charge it.
OFF: do not charge after inserting the gun, you must click "ENABLE" on APP to recharge.
New energy load balancing model (ECO mode):ECO mode: when CT detects that the current of solar power
generation exceeds 6A, the charger can be charged entirely by solar energy. If the solar current is less than 6A,
the charger will charge at the current of 6A, and the deficiency will be provided by the power grid. When it is
detected that the solar power generation current is greater than 6A, the charging current is charged
according to the solar power generation current, and the maximum output current does not exceed the
maximum output current of the charger.
Note: in order to prevent some cars from going into dormancy and unable to wake up, the minimum current
should be kept at 6A after plug and play charging in solar mode, so that when the solar current is less than 6A,
the car will go into dormancy and cannot be recharged.
If you need to charge quickly, you can select "Plug and charge" and select "ON" to enter the charging state.
Choose plug and charge mode or timing mode, which is the maximum allowed charging output mode.
The plug and play mode of APP has an on key. If you select ON in plug and play mode, then plug the gun and
charge it. If you choose OFF mode, you need to click "ENABLE" on APP to recharge. And regardless of whether
it is in timing mode or plug and play mode, as long as the start is clicked on the APP, the charger will enter the
charging state.
ECO: solar energy balance load, energy saving mode does not have solar energy balance load, this function is
invalid.
If device has fault, you can view the cause of the failure in the center of the main
interface of the APP.
APP INSTRUCTION
FAULT INTERFACE
22
V.1