Publicidad
Idiomas disponibles
Idiomas disponibles
Auto Shutdown Protection
Auto shut down is a safety protection
function for your induction hob. It shut
down automatically if ever you forget to
turn off your cooking. The default working
times for various power levels are shown in
the below table:
Power level
Default working
timer (min)
When the pot is removed, the induction
hob can stop heating immediately and the
hob automatically switch off after 2 minute.
People with a heart pace maker
should consult with their doctor before
using this unit.
Cooking vessels (Fig. 3)
- a magnet-attracting vessel may be a
suitable vessel for induction cooking
- prefer vessels which are especially
declared to be suitable for induction cooking
- flat- and thickbottomed vessels
- a vessel with the same diameter as zones
ensures the maximum exploitation of power
- a smaller vessel reduces power
exploitation, but does not cause any energy
loss We would anyhow not recommend the
use of vessels with diameters smaller than
10 cm.
- stainless-steel vessels with multi-layer or
ferritic stainless-steel bottoms when
specifically suited for induction cooking
- cast-iron preferably enamel-bottomed
vessels to avoid scratchmg the pyroceram
surface
- we do not recommend the use of any
glass, ceramic, earthenware, alluminium,
copper 0r non-magnetic (austenitic)
stainlesssteel vessels
Maintenance (Fig. 4)
By means of a scraper immediately
remove any alluminium foil bits, food spills,
grease splashes, sugar marks and other
high sugarcontent food from the surface in
order to avoid damaging the hob.
1~3
4~6
7~8
240
180
120
Subsequently clean the surface with some
towel and appropriate product, rinse with
water and dry by means of a clean cloth.
Under no circumstance should sponges or
abrasive cloths be used; also avoid using
aggressive chemical detergents such as oven
sprays and spot removers.
9
lnstaller's Instructions
Installation
90
These Instructions are for the qualified
technician, as a guide to installation,
adjustment and maintenance, according to
the laws and standards in force. These
operations must always be carried out when
the appliance has been disconnected from the
electric system
Positioning (Fig. 5)
The fixture is especially designed tor fitting
into a work-top as shown in the corresponding
figure.
Place the supplied sealing agent along the
hob perimeter
Do not install the hob over an oven; in case
you do, make sure of the following:
- the oven is equipped with an appropriate
cooling system
- there is no warm-air leakage from the oven
towards the hob suitable air-inlets are
provided as shown in the figure.
Electrical connection (Fig. 6)
Prior to carrying out the electrical connection,
please ensure that: the plant characte廿stics
are such as to follow what is indicated on the
matrix plate placed at the bottom of the
working area;
that the plant is fitted with an efficient earth
connection, following the standards and law
provisions in force.
The earth connection is compulsory in terms
of the law.
Should there be no cable and/or plug on the
equipment, use suitable absorption material
for the working temperature as well, as
indicated on the matrix plate. Under no
circumstance must the cable reach a
temperature above 50°C of the ambient
temperature.
14
Publicidad
