SSS Siedle Touch 10 Informacion De Producto página 13

LED signalling (LEDs on ST 10-... installation pcb)
Switching on
Red LED Green LED
On On
On Off
Flashes slowly Off
Flashes rapidly Off
Flashes slowly Flashes slowly
Operation
Red LED Green LED
Off On
Fault
Red LED Green LED
Flashes slowly On
Flashes rapidly On
Frequencies: Slow appr. 2 Hz, fast appr. 16 Hz
Function
After reset, power on: Device boots to operating status.
The boot area is checked. Software runs in the flash.
Vario bus address error
General error when checking the boot area
Error when starting the software
Function
Booting is complete. All OK.
Normal status
Function
Vario bus address error (error remedy possible on site)
The 12 V power supply (terminal bv, cv) is overloaded.
(Error remedy possible on site)
13