Orthofix AccelStim Manual De Instrucciones página 12

Starting a Treatment
Ver 1.0
19:48
11
5. Insert the transducer inside the transducer holder so that the serial
number is visible.
6. Close the blue cover by rotating it clockwise.
1. Turn on the device by pressing the on/off button for two seconds. Once
you hear a beep, release the button, and the display screen will light up.
2. The Orthofix logo will appear on the display screen as the device
powers on.
3. The device will display 20 minutes of treatment time along with a play
symbol to specify that the device is now ready for treatment. The gel
symbol will flash for 10 seconds to remind the user to apply the
ultrasound gel on the transducer before starting treatment.
4. To start the treatment, press the function button on the front panel of
the device. The AccelStim device signals the start of treatment with a
beep. During treatment, the display shows the remaining therapy time.
NOTE: The AccelStim device will power down automatically after two
minutes of inactivity, to reduce battery consumption.
5. To pause the device in the middle of a treatment, press the
function button and the treatment will stop. The display will
show a pause symbol with the remaining treatment time
stopped. To resume treatment, press the function button again
6. Once the treatment screen reaches zero, the display screen will
show a checkmark to specify treatment completed and
emit three beeps. After 30 seconds, the AccelStim device will
automatically turn off.