Descargar Imprimir esta página

Zipper ZI-STE3000IV Instrucciones De Servicio página 33

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 39
13.6.2
Switch the machine off
In case of emergency stop the machine directly with the ON-OFF switch.
Under normal circumstances, switch off the machine as follows:
Shut down the connected devices and disconnect them from the machine.
Let the machine run for some time without connected devices to cool down.
Switch off the machine by putting the ON-OFF switch to position „OFF".
At longer breaks: Let the machine run for some time without connected devices to cool down.
Thereafter close the fuel tap by turning to position „OFF". The engine runs until the remaining
fuel is consumed in the carburettor.
Switch off the machine by putting the ON-OFF switch to position „0".
13.6.3
ECO-mode
13.6.4
Teleskope handle
ZIPPER MASCHINEN GmbH
www.zipper-maschinen.at
• At cold start set the choke (3) to position „START".
• If the engine runs smoothly set the choke (3) to position
„RUN".
• At warm start (the engine was running and is still warm) set
choke (3) to position „RUN".
If the engine fails to start after 5 attempts, set the choke to
position "START" and try again.
• Start the engine with the recoil starter.
Grab the starter handle (4) and pull it out slowly. The re-
sistance becomes strongest at a certain point. This point cor-
responds to the compression point. Let the rope roll back a
little from this point and then pull it out powerfully.
Slowly return the starter handle (4).
If the engine does not start, try again.
Normally start: 3-4 attempts.
C AU TI O N
The ECO-mode is recommended to reduce fuel consumption
during operation.
With the activated ECO-mode, the machine automatically re-
duces the engine speed depending on the load. This results in
less fuel consumption.
NOTE:
In case of low power output, the ECO-mode can be acti-
vated (switch (1) in position "I").
In case of high power output and DC operation, the ECO-mode
must always be deactivated (switch (1) in position "0").
• By pressing the unlocking button (2), the length of the tele-
scope handle (1) can be adjusted.
OPERATION
33
ZI-STE3000IV

Publicidad

loading