Zipper ZI-STE3000IV Instrucciones De Servicio página 35

14.2 Maintenance
The machine is low-maintenance and only a few parts need to be serviced. Malfunctions or defects that
could affect your safety must be repaired immediately!
• Before each operation, check the perfect condition of the safety devices.
• Regularly check the perfect and legible condition of the warning and safety labels of the ma-
chine.
• Use only proper and suitable tools.
• Use only original spare parts recommended by the manufacturer.
14.2.1 Maintenance plan
The type and degree of machine wear depends to a large extent on the operating conditions. The following
intervals apply when the machine is used within the technical limits:
(1) Interval can vary accord-
ing to the air quality
(2) Only by specialists!
Control
the level
Engine oil
Change
Control
Air filter
Change
Control
Spark plug
Change
Control
Fuel tank and
fuel filter
Change
14.2.2 Engine oil change
Waste oils and fuel are toxic and must not be released into the environment!
Contact your local authorities for information on proper disposal.
Drain the used engine oil while it is still warm from operating the machine (drains easier).
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
Prior to (for new
each machine)
start after first
Month or 5
operation
hours
X
X
X
X
N O TE
• Place the machine on a flat surface.
• Loosen the screws (2) and remove the cover (1).
• Open the oil drain plug (3).
• Drain the old oil into a suitable container.
• Close the oil drain plug (3) again.
Every 3 Every 6
months months
or every or every
25 oper- 50 oper-
ation ation
hours hours
X
X (1)
X (2)
Every 12 Every 2
months years or
or every every
100 op- 250 op-
eration eration
hours hours
X
X
35
ZI-STE3000IV