Zipper ZI-STE3000IV Instrucciones De Servicio página 38

15 TROUBLESHOOTING
If you are unable to carry out the necessary repairs properly and/or do not have the required training, always
consult a specialist to solve the problem.
Trouble
Engine does not start
Engine starts and
stalled immediately
Machine works with inter-
ruptions
Low oil light glows
Overload indicator light
glows
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
Possible cause
• Incorrect starting sequence
• Dirty air filter
No fuel supply
•
Fault in the fuel line
•
Engine flooded
•
Spark plug connector not
•
placed on
No ignition spark
•
Fuel tap closed
•
• Insufficient engine oil
is
Incorrect idle adjustment
•
Carburettor
•
• Spark plug fouled
• Check engine oil level
To less or no engine oil
•
• High temperature protection
activated
• Overload protection activated
• Short circuit protection acti-
vated
TROUBLESHOOTING
Solution
• Observe the correct starting
sequence
• Clean/replace air filter
Refuel
•
Check the fuel line for kinks
•
or damages
• Screw off, clean and dry the
spark plug. Then pull the
cranking rope several times
and reinstall the spark plug
Place on the spark plug
•
connector
Clean/replace spark plug
•
Check ignition cable
•
Open fuel tap
•
• Check engine oil level
Contact the service team
•
Contact the service team
•
Clean/replace spark plug
•
• Check spark plug connector
• Fill engine oil
Fill engine oil
•
Cool down the engine
•
• Reduce existing load
• Check loads
38
ZI-STE3000IV