Euroflex vapour M2R Manual De Instrucciones página 13

C. Using Steam
C. USING STEAM (continued)
• To emit steam from the Steam
• To emit steam from the Front Jets,
Nozzles, pull the trigger on
pull the trigger on the handle
the Handle upward.
upward.
*IMPORTANT*
The Steam Nozzles are meant
to be used in steam "bursts"
and should never be used on
a sustained basis. The Steam
IMPORTANT
*
Nozzles will loosen especially
difficult debris and will assist in
The Steam Jets are meant to be used in steam "bursts" and should
cleaning hard to reach areas
never be used on a sustained basis. The Steam Jets will loosen
such as floor edges.
especially difficult debris and will assist in cleaning hard to reach
areas such as floor edges.
The Floor Steamer will stop producing steam when the Boiler is
empty. When this happens unplug and store unit or refill with water
per instructions (below).
NOTE: Your Steam Cleaner will not need refilling for about 20-25
NOTE: If the Floor or Carpet Pad becomes too wet or too dirty, replace with a
minutes of usage.
clean, dry Pad and continue cleaning.
The Steam Cleaner will stop producing steam when the Boiler is
empty. When this happens unplug and store unit or refill with water
per instructions below.
D. Refilling Boiler During Use
NOTE: If the Floor or Carpet Pad becomes too wet or too dirty, replace
When the Floor Steamer has run out of water, there will be no more
with a clean dry pad and continue cleaning.
steam coming out of the unit. At this stage it is time to refill the Boiler.
Follow the refilling instructions below.
D. REFILLING BOILER DURING USE
When the Steam Cleaner has run out of water, there will be no more
*IMPORTANT*
steam coming out of the unit. At this stage it is time to refill the Boiler.
Follow the refilling instructions below. The Floor Steamer has a Boiler that should not be overfilled. To avoid the
potential for overfilling, only refill the Boiler when it is completely run out of
water and only add 600ml. Always follow the practice of using the Floor Steamer
IMPORTANT
until it has run out of water and then refill 600ml only.
*
If floor cleaning is completed and water remains in the Boiler, the Floor Steamer
Use the filling bottle when refilling your Boiler. The filling bottle has a
can be stored with the remaining water in the Boiler, there will be no harm done
built-in mechanism that prevents overfilling your Boiler. If you use a
to the unit. At the next cleaning session simply heat up the unit and use the
water already in the Boiler, then refill when empty.
measuring cup to refill, add a maximum of 600ml (2 1/2 cups) of water
when the Boiler is empty.
Or alternatively at the next cleaning session, open the Boiler Cap when the unit
is still cold and pour out the water and then refill (if this alternative method is
If cleaning is completed and water remains in the Boiler, the Steam
used, it is recommended that only 500ml of water is added, because the unit
Cleaner can be stored with the remaining water in the Boiler. There will
will not completely drain when the water is poured out from the Boiler).
be no harm done to the unit. At the next cleaning session simply fill the
Boiler using the filling bottle.
WARNING: Let Steamer cool 5 minutes before opening Boiler Cap.
Use care when opening Boiler Cap as it may still be hot and steam
WARNING: Let Steam Cleaner cool 5 minutes before opening
may escape, causing burns. If Boiler is still hot, water may spurt out
Boiler Cap. Use care when opening Boiler Cap as it may still be hot
during refilling which can also cause burns.
and steam may escape, causing burns. If Boiler is still hot, water
may spurt out during refilling which can also cause burns.
10
Using Your Floor Steamer
(continued)
*
*
NOTE: Your Steamer will not need
refilling for about 20-25 minutes
of usage.
Using the Steam Cleaner
13